The purpose of this device is to convert prime mover’s energy into kinetic energy, then into pressure energy that helps in pumping the fluid.
These energy changes take place courtesy of two main centrifugal pump components – the volute or diffuser and the impeller.
The diffuser is the stationary part which converts kinetic into pressure energy while the impeller is the component that rotates and transforms driver force into kinetic energy.
There are two main components in a centrifugal pump:
Rotating system made up of a shaft and an impeller
A stationary part made up of a casing, its cover, and bearings
All these components are instrumental in ensuring that the pump can operate as required.
With the combination of these elements, the centrifugal pump can move fluid by accelerating the liquid radially outward.
These kinds of pumps consist of one or more impellers in a casing that guides the fluid in and out of the impeller, or from one impeller to another in multistage pumps.
The impellers can be single or double suction.
The rotating impeller conveys kinetic energy and pressure to the fluid. A collection zone in the casing transforms a significant portion of the kinetic energy into pressure energy before allowing the fluid to leave the pump.
Through the impeller, a free passage exists between the inlet and discharge side of the pump.
To prevent the draining or back-flow of fluid from the centrifugal pump, there is a need to ascertain that the impeller is rotating.
As a result, only a few centrifugal pumps are self-priming. A good number of pumps must be primed or filled with liquid before they can start.
Other components of the centrifugal pumps are:
Rings or wearing surfaces which create a running joint between the casing and the impeller to reduce fluid backflow from discharge to suction
The shaft that drives and supports the impeller, and
The seal or stuffing box that prevents leakages from occurring between the shaft and casing
The bearing housing encloses the bearings that are mounted on the shaft.
These bearings keep the rotor in alignment with the stationary components under the actions of transverse or radial loads.
The bearing system also incorporates a constant level oiler, an oil reservoir for the lubrication, and a jacket for cooling through cold water circulation.
Every centrifugal pump has a characteristic curve that illustrates the relation between the rate of flow or capacity and head or pressure against which the device will pump.
At a pressure difference of zero, maximum capacity is achieved in the absence of useful work. As the external flow resistance increases, the capacity decreases until flow ceases at a high pressure.
This is referred to as a shut-off head, and at this point, there is no work done. At constant rpm, the head and capacity differ in a fixed relationship.
When the needed head surpasses the practical for a single-stage pump, many phases are employed.
We own more than 300 sets of advanced production and inspection equipment to manufacture products of various categories and specifications.
Our main products are sold best in Europe and Southeast Asia .
sincerely hope to cooperate with new and old customers from all over the world to gain mutual benefits.